User's Manual
Table Of Contents
- 1 VIPER OVERVIEW
- 2 SYSTEM ARCHITECTURE AND NETWORK PLANNING
- 3 DATARADIO VIPER QUICK START
- 4 VIPER WEB MANAGEMENT
- 5 UNIT STATUS
- 6 SETUP (BASIC)
- 7 SETUP (ADVANCED)
- 7.1 RF OPTIMIZATIONS
- 7.2 IP SERVICES
- 7.3 IP ADDRESSING
- 7.4 IP OPTIMIZATION
- 7.5 IP ROUTING (TABLE/ENTRIES)
- 7.6 TIME SOURCE
- 7.7 ALARM REPORTING
- 7.8 USER SETTINGS
- 8 SECURITY
- 9 STATISTICS
- 10 MAINTENANCE
- 11 NEIGHBOR MANAGEMENT
- 12 NETWORK OPTIMIZATION
- 13 UPGRADING YOUR FIRMWARE
- VIPER SPECIFICATIONS
- PRODUCT WARRANTY
- DEFINITIONS
001-5008-000(Rev8) Page 96
Reliable Service Msg Success Count
ust be enabled
order to generate a Reliable Service Message. RF Acknowledgements can be configured
under Setup (Advanced) D IP Optimization (Router Mode Only).
Reliable Service Msg Failure Count
The number of service messages that failed.
Total Retry Count
The total number of retries for service messages.
Noise Detected Count
The number of noise (non Viper carrier) detected instances above the carrier sense level. If
the Carrier Sense Threshold should
be raised.
RX Total "Other" Count
his is the total number of messages the Viper overheard that were intended for another
station. These messages are discarded.
The number of service messages that succeeded. RF Acknowledgements m
in
the Noise detected count is high, it may be an indication
T