User's Manual
Table Of Contents
- 1 VIPER OVERVIEW
- 2 SYSTEM ARCHITECTURE AND NETWORK PLANNING
- 3 DATARADIO VIPER QUICK START
- 4 VIPER WEB MANAGEMENT
- 5 UNIT STATUS
- 6 SETUP (BASIC)
- 7 SETUP (ADVANCED)
- 7.1 RF OPTIMIZATIONS
- 7.2 IP SERVICES
- 7.3 IP ADDRESSING
- 7.4 IP OPTIMIZATION
- 7.5 IP ROUTING (TABLE/ENTRIES)
- 7.6 TIME SOURCE
- 7.7 ALARM REPORTING
- 7.8 USER SETTINGS
- 8 SECURITY
- 9 STATISTICS
- 10 MAINTENANCE
- 11 NEIGHBOR MANAGEMENT
- 12 NETWORK OPTIMIZATION
- 13 UPGRADING YOUR FIRMWARE
- VIPER SPECIFICATIONS
- PRODUCT WARRANTY
- DEFINITIONS
001-5008-000(Rev8) Page 95
X
he total number of output bytes transmitted by the port.
RX Pkts
The total number of input packets received by the port.
TX Pkts
The total number of output packets transmitted by the port.
9.3 RF
RX Pkts (OIP Sublayer)
The total number of input packets received by RF-OIP interface.
TX Pkts (OIP Sublayer)
The total number of output packets transmitted by RF-OIP interface.
RX Ctrl Pkts (Airlink Sublayer)
The total number of control packets received over-the-air. These packets may be RTS/CTS
messages or RF Acknowledgements.
RX Data Pkts (Airlink Sublayer)
The total number of input data packets received over-the-air.
TX Ctrl Pkts (Airlink Sublayer)
The total number of out r. These packets may be
TS/CTS messages or
k Sublayer)
put data packets transmitted over-the-air.
Airlink parameters provide the user with RF link quality information.
T Pkts (LAN)
The total number of output packets transmitted by the Ethernet interface.
9.2 SERIAL
RX Bytes
The total number of input bytes received by the port.
TX Bytes
T
put control packets transmitted over-the-ai
RF Acknowledgements. R
TX Data Pkts (Airlin
The total number of out
9.4 AIRLINK ERROR DETECTION