User's Manual

8.4.1 VPN Configuration
Figure 8.6 - VPN Settings
VPN can be manually enabled or disabled at any time on each Vipe y clicking “Enable
VPN” or “Disable VPN” buttons (see Figure 8.6).
Notes:
ly
In order to gain access to VPN Configuration you need a valid VPN password. If the
password was never set before you can leave the field blank.
Note: The VPN password and the Master Key must be set b N can be enabled.
It is possible to reset both VPN access password and the Ma ey by clicking the “Clear
Password and Master Key” button. This could be used to cl existing VPN configuration
or in cases where either the VPN access password or the Master Key is lost.
VPN Statistics
r unit b
• VPN is available in router mode only.
• You can use basic AES Encryption and VPN at the same time as they are mutual
exclusive
efore VP
ster K
ear an
Item Description
Number of Tunnels
tics a played for all tunnels. This value represents the
total number of e tunnels terminating in the unit.
Note: The maximum number exchanging tunnels is currently
limited to 128 on a VPN ser on a VPN client.
A “shared” tunnel is also in n this statistic. It is used for special
types of traffic such as broadcast and multicast packets. The tunnel is
always keyed, so the minimum Number of Tunnels shown is 1 when
VPN statis re dis
activ
of key-
ver and 1
cluded i
VPN is enabled on the device.
Tunnels Ready
Number of tunnels that are accepting traffic.
Note: Tunnels that are not ready block all traffic passing through them.
001-5008-000(Rev8) Page 88