User's Manual

credential, check for a match against the RADIUS server credential database.
ccessing the HTTP server, check the user credentials against the RADIUS
server. If the user credentials fail to match with the RADIUS server, access to the HTTP
In order for any Radius authentication to work, the Client settings under Radius
must be properly configured.
RADIUS- When a
server is denied.
Configuration (see Figure 8.2)
Figure 8.2 – Radius Configuration
Radius Client Configuration
Parameter name Description Comments
RADIUS Server IP The server’s IP address
RADIUS Server Port The server’s IP port Any port can be used but most
common values are 1812 or 1645.
Note:
These are the only values
n a supported for RADIUS login o
non-access point device that uses
the VPN feature.
RADIUS Secret Request encryption key The same value must be set in the
RADIUS server.
RADIUS Timeout Timeout in seconds on the
RADIUS’ server reply before a
new request is generated.
Default value is 5 seconds.
RADIUS Retries Number of retries before Default value is 5.
declaring a RADIUS fault.
Delay between
retries
Delay in seconds between
retries.
Default value is 3 seconds
001-5008-000(Rev8) Page 85