User's Manual
Table Of Contents
- 1 VIPER OVERVIEW
- 2 SYSTEM ARCHITECTURE AND NETWORK PLANNING
- 3 DATARADIO VIPER QUICK START
- 4 VIPER WEB MANAGEMENT
- 5 UNIT STATUS
- 6 SETUP (BASIC)
- 7 SETUP (ADVANCED)
- 7.1 RF OPTIMIZATIONS
- 7.2 IP SERVICES
- 7.3 IP ADDRESSING
- 7.4 IP OPTIMIZATION
- 7.5 IP ROUTING (TABLE/ENTRIES)
- 7.6 TIME SOURCE
- 7.7 ALARM REPORTING
- 7.8 USER SETTINGS
- 8 SECURITY
- 9 STATISTICS
- 10 MAINTENANCE
- 11 NEIGHBOR MANAGEMENT
- 12 NETWORK OPTIMIZATION
- 13 UPGRADING YOUR FIRMWARE
- VIPER SPECIFICATIONS
- PRODUCT WARRANTY
- DEFINITIONS
Daylight Saving
Select: Enabled, Disabled; Default: Disabled
7.7 ALARM REPORTING
Figure 7.26 - Setup (Advanced)
D
Alarm Reporting
The Viper radio can be enabled to report several different types of alarms using the SNMP
protocol. If SN orting is enabled for
a specific alarm, resses listed in the
Trap IP List (Setup (Advanced) – IP Services) henever an alarm occurs.
that caused the alarm clears, the Viper will send a second SNMP Trap to
d Power Alarm will trigger when the measured forward power drops 1 dB or more
power. The Forward Power Alarm SNMP trap is
the forward power returns to within 0.8 dB of
econd notification is sent indicating the error
s
me the Viper is programmed to transmit at 10W. If the measured
the SNMP Trap or Alarm is
ed and a second
fication is generated.
rse Power Alarm & Notification
th the Power Amplifier or
sconnected. The alarm will trigger when the
within 3 dB of the user configured transmit power.
Power Alarm SNMP trap is generated when this condition occurs. When the
d and a second
the Viper is programmed to transmit at 10W. If the measured reverse
above 5.0W then the error is detected and the SNMP Trap or Alarm is
se power then drops below 3.1W the error is cleared and a second
MP is enabled (Setup (Advanced) – IP Services) and rep
the Viper will send an SNMP T ap to each of the IP addr
w
If the condition
each of the IP addresses listed in the Trap IP List, indicating that the error has cleared.
7.7.1 Forward Power Alarm & Notification
The Forwar
below the user configured transmit
generated when this condition occurs. When
the wanted power the error is cleared and a s
ha cleared.
For example, assu
forward power drops below 7.9W then the error is detected and
generated. If the forward power then rises above 8.3W the error is clear
SNMP Trap or Noti
7.7.2 Reve
The Reverse Power Alarm will warn the user of a major problem wi
Antenna, such as the antenna becoming di
measured reverse power increases to
The Reverse
reverse power drops 5 dB below of the wanted power the error is cleare
notification is sent indicating the error has cleared.
For example, assume
power increases
generated. If the rever
SNMP Trap or Notification is generated.
001-5008-000(Rev8) Page 81