User's Manual

 On-line diagnostics Interval
Displays the time interval in seconds when the On-line Diagnostics will be transmitted. This
interval can be configured under Setup (Basic) D General D On-line diagnostics interval.
 VPN Status
Displays the status of the VPN (virtual private network).
Displays “ OK, ready” when operational.
Displays “Not Ready” and a reason, example” VPN service disabled”, when not operational
 Unit Status
Displays the status of the Viper and reports any errors. If you do not receive the OK
indicator (EX. Error: Power On Self Test FAILURE, Warning: Radio TX Synthesizer lock
failure N/A), use the ACKNOWLEGDE UNIT STATUS and REFRESH buttons to reset the
modem. If the problem persists, contact CalAmp Technical Services for additional
information.
Have the displayed Unit Status message available if contacting CalAmp support. This
information is also required if returning a unit for service under RMA.
 Refresh
This button will refresh the parameters on the current page.
 Acknowledge Unit Status
This button allows the user to acknowledge and clear errors.
Errors remain stored, even after cycling power, to aid in troubleshooting intermittent faults.
Press the "Acknowledge Unit Status" button to return web page displays and Status LED
function to normal operation.
5.2 DIAGNOSTICS
Viper units continually monitor and report on their environmental and operating conditions.
5.2.1 Local Diagnostics
Local Diagnostics can be accessed by loading the Unit Status D Diagnostics web page from
the Viper.
Figure 5.2 - Unit Status
D Diagnostics Web Page
001-5008-000(Rev8) Page 41