User's Manual
Table Of Contents
- 1 VIPER OVERVIEW
- 2 SYSTEM ARCHITECTURE AND NETWORK PLANNING
- 3 DATARADIO VIPER QUICK START
- 4 VIPER WEB MANAGEMENT
- 5 UNIT STATUS
- 6 SETUP (BASIC)
- 7 SETUP (ADVANCED)
- 7.1 RF OPTIMIZATIONS
- 7.2 IP SERVICES
- 7.3 IP ADDRESSING
- 7.4 IP OPTIMIZATION
- 7.5 IP ROUTING (TABLE/ENTRIES)
- 7.6 TIME SOURCE
- 7.7 ALARM REPORTING
- 7.8 USER SETTINGS
- 8 SECURITY
- 9 STATISTICS
- 10 MAINTENANCE
- 11 NEIGHBOR MANAGEMENT
- 12 NETWORK OPTIMIZATION
- 13 UPGRADING YOUR FIRMWARE
- VIPER SPECIFICATIONS
- PRODUCT WARRANTY
- DEFINITIONS
5
UN
5 UN
IT
STATUS
IT STATUS
The Unit Status windows display device General and Diagnostic information.
5.1 UNIT IDENTIFICATION AND STATUS
Figure 5.1 - Unit Status D General Web Page
Banner
The unit identification and status banner displays Viper software revision information for the
Viper device. Have this information available if contacting CalAmp support.
The banner should read: Dataradio Viper FAMA UHFVHF PROD Vx.y_Rxxx, where:
Product Name Viper
Protocol Name Licensed
Band(s) of Operation VHF 136-174 MHz / 215-240 MHz,
UHF 406.1-512 MHz, 900 928-960 MHz
Production Build Vx.y Rxxx where
Vx.y is Major.minor version number, and
Rxxx is Sequential Package Release Build Number
Station Name
Displays the name of the connected unit. Configured under Setup (Basic) D General D
Station Name.
001-5008-000(Rev8) Page 39