User's Manual
Table Of Contents
- 1 VIPER OVERVIEW
- 2 SYSTEM ARCHITECTURE AND NETWORK PLANNING
- 3 DATARADIO VIPER QUICK START
- 4 VIPER WEB MANAGEMENT
- 5 UNIT STATUS
- 6 SETUP (BASIC)
- 7 SETUP (ADVANCED)
- 7.1 RF OPTIMIZATIONS
- 7.2 IP SERVICES
- 7.3 IP ADDRESSING
- 7.4 IP OPTIMIZATION
- 7.5 IP ROUTING (TABLE/ENTRIES)
- 7.6 TIME SOURCE
- 7.7 ALARM REPORTING
- 7.8 USER SETTINGS
- 8 SECURITY
- 9 STATISTICS
- 10 MAINTENANCE
- 11 NEIGHBOR MANAGEMENT
- 12 NETWORK OPTIMIZATION
- 13 UPGRADING YOUR FIRMWARE
- VIPER SPECIFICATIONS
- PRODUCT WARRANTY
- DEFINITIONS
001-5008-000(Rev8) Page 38
relevant parameter(s). Failure to use the “Apply” command button before leaving a
web page will result in the loss of entered selections, addresses, and values.
Cancel
The “Cancel” command only affects the dialog boxes or radio buttons in the opened window.
Save Config
This command button saves the Viper parameters into flash memory. Failure to use this
command button will result in the loss of temporarily entered parameters when the unit is
reset.
Reset Unit
Once satisfied all parameters have been applied and saved, use the “Reset Unit” command
button to make flash changes permanent. When a unit is reset, a 20-second station reset
timer counts down. Status reports Ready when reset is complete.