User's Manual
Table Of Contents
- 1 VIPER OVERVIEW
- 2 SYSTEM ARCHITECTURE AND NETWORK PLANNING
- 3 DATARADIO VIPER QUICK START
- 4 VIPER WEB MANAGEMENT
- 5 UNIT STATUS
- 6 SETUP (BASIC)
- 7 SETUP (ADVANCED)
- 7.1 RF OPTIMIZATIONS
- 7.2 IP SERVICES
- 7.3 IP ADDRESSING
- 7.4 IP OPTIMIZATION
- 7.5 IP ROUTING (TABLE/ENTRIES)
- 7.6 TIME SOURCE
- 7.7 ALARM REPORTING
- 7.8 USER SETTINGS
- 8 SECURITY
- 9 STATISTICS
- 10 MAINTENANCE
- 11 NEIGHBOR MANAGEMENT
- 12 NETWORK OPTIMIZATION
- 13 UPGRADING YOUR FIRMWARE
- VIPER SPECIFICATIONS
- PRODUCT WARRANTY
- DEFINITIONS
001-5008-000(Rev8) Page 114
1 s Limit
in Router mode. The MAC Retry Limit is
rmally set to 2. Gradually increasing these
limits (up to 3 in extreme cases), may provide a slower, but more reliable link impossible
the
2.2.3 Increase OIP and MAC Retrie
OIP retries and MAC retries are only available
normally set to 1 and the OIP Retry Limit is no
with weak signals. Use in conjunction with the slower over-the-air network bit rate for
system’s bandwidth.
The number of MAC retries can be configured on the Viper’s web pages under Setup
(Advanced) D RF Optimizations. The number of OIP retries can be configured under Setup
(Advanced) D IP Optimization.