User's Manual
Table Of Contents
- 1 VIPER OVERVIEW
- 2 SYSTEM ARCHITECTURE AND NETWORK PLANNING
- 3 DATARADIO VIPER QUICK START
- 4 VIPER WEB MANAGEMENT
- 5 UNIT STATUS
- 6 SETUP (BASIC)
- 7 SETUP (ADVANCED)
- 7.1 RF OPTIMIZATIONS
- 7.2 IP SERVICES
- 7.3 IP ADDRESSING
- 7.4 IP OPTIMIZATION
- 7.5 IP ROUTING (TABLE/ENTRIES)
- 7.6 TIME SOURCE
- 7.7 ALARM REPORTING
- 7.8 USER SETTINGS
- 8 SECURITY
- 9 STATISTICS
- 10 MAINTENANCE
- 11 NEIGHBOR MANAGEMENT
- 12 NETWORK OPTIMIZATION
- 13 UPGRADING YOUR FIRMWARE
- VIPER SPECIFICATIONS
- PRODUCT WARRANTY
- DEFINITIONS
001-5008-000(Rev8) Page 112
Single Station allows the user to enter the single RF MAC Address
Single Station
of the Viper module
commands will be sent to. If this option is selected, the command will be sent to an
of being sent to all Vipers in the Network.
ill not be sent until the "Apply" button is clicked.
11.9 RECOMMENDED NEIGHBOR DISCOVERY MODES OF OPERATIONS
CalAmp recommends Auto-Scan be limited to Viper networks of two to ten units. If Auto-
Scan mode is used, be aware that the Neighbor Discovery learning process may slow
responses in SCADA networks from remote units or capture the RF channel so remotes
cannot respond to a Master.
Manual-Scan is recommended for most projects.
Disabled is recommended in projects where the customer does not want RF paths to deviate
from RF engineered (RF Site Survey completed) paths.
individual Viper instead
Apply
The commands w