User's Manual
Table Of Contents
- 1 VIPER OVERVIEW
- 2 SYSTEM ARCHITECTURE AND NETWORK PLANNING
- 3 DATARADIO VIPER QUICK START
- 4 VIPER WEB MANAGEMENT
- 5 UNIT STATUS
- 6 SETUP (BASIC)
- 7 SETUP (ADVANCED)
- 7.1 RF OPTIMIZATIONS
- 7.2 IP SERVICES
- 7.3 IP ADDRESSING
- 7.4 IP OPTIMIZATION
- 7.5 IP ROUTING (TABLE/ENTRIES)
- 7.6 TIME SOURCE
- 7.7 ALARM REPORTING
- 7.8 USER SETTINGS
- 8 SECURITY
- 9 STATISTICS
- 10 MAINTENANCE
- 11 NEIGHBOR MANAGEMENT
- 12 NETWORK OPTIMIZATION
- 13 UPGRADING YOUR FIRMWARE
- VIPER SPECIFICATIONS
- PRODUCT WARRANTY
- DEFINITIONS
To query the Viper for the status of all its neighbors, select the Get Status option then press
1.8 MAINTENANCE
The Network Maintenance page allows the user to make changes to a single Viper unit or
the entire Viper network. This allows the user to make changes to the remote units'
neighbor tables.
the "Apply" button under Network Management D Maintenance.
1
Figure 11.6 - Network Maintenance
f
ation
ed) and the new RF MAC
Address (that will replace the old Viper). This will update the Neighbor Table of all the
l-
Save Configuration
This will send a save configuration command to all Vipers in the network.
Get Status
This will send a "Get Status" command to all Vipers in the network. The status will be
displayed on the Network Management D Status page.
Delete Station
The user enters the RF MAC Address of the station to be deleted from the Neighbor Table o
all Vipers in the network.
Replace St
The user enters the old RF MAC Address (the unit to be replac
Vipers in the network.
Change ND mode
The user can change the Neighbor Discovery mode of all Vipers in the network to Manua
Scan, Auto-Scan, or Disable.
001-5008-000(Rev8) Page 111