User's Manual

001-5008-000(Rev8) Page 107
 Testing Connectivity
The neighbor discovery module is verifying the Viper units in the neighbor table are
reachable by sending them an alive-request and waiting for an alive-response. Round trip
time must not exceed 10 seconds. The alive-request is only sent once.
 Disabled
The neighbor discovery module is disabled.
11.3.2 Neighboring Vipers Found
Displays the number of Vipers discovered.
11.3.3 Discovery Duration
Discovery Duration is the time it took for the Viper unit to complete the neighbor discovery
learning process.
11.4 DISCOVERED VIPER NEIGHBORS
Each entry in the Neighbor Table represents a remote Viper. See Figure 11.1: Discovered
Viper Neighbors.
11.4.1 Information on Neighboring Vipers
 RF MAC Address
Identifies each entry uniquely. The user can click the RF MAC ADDRESS entries to display
eighbor Node Detail window.
ddress and Ethernet IP Address
y Type
the user. The entry type can only be removed by the user.
T is entry cannot be replaced by a "Dynamic" or "Locked" entry.
e “Save” button from the web page, all "Static" neighbor entries are
are recovered after a reboot.
the details of the selected device in the N
 RF IP A
Used to build the routing table.
 Discovery Mode
Represents the Mode of operation of the remote Unit. See section 11.2 for more
information on Neighbor Discovery Modes.
11.4.2 Neighbor Table Entr
 Static
This entry has been defined by
h
"Static" neighbor entries can be added in any neighbor discovery mode.
If the user presses th
saved in nvram. They