User's Manual
Table Of Contents
- 1 VIPER OVERVIEW
- 2 SYSTEM ARCHITECTURE AND NETWORK PLANNING
- 3 DATARADIO VIPER QUICK START
- 4 VIPER WEB MANAGEMENT
- 5 UNIT STATUS
- 6 SETUP (BASIC)
- 7 SETUP (ADVANCED)
- 7.1 RF OPTIMIZATIONS
- 7.2 IP SERVICES
- 7.3 IP ADDRESSING
- 7.4 IP OPTIMIZATION
- 7.5 IP ROUTING (TABLE/ENTRIES)
- 7.6 TIME SOURCE
- 7.7 ALARM REPORTING
- 7.8 USER SETTINGS
- 8 SECURITY
- 9 STATISTICS
- 10 MAINTENANCE
- 11 NEIGHBOR MANAGEMENT
- 12 NETWORK OPTIMIZATION
- 13 UPGRADING YOUR FIRMWARE
- VIPER SPECIFICATIONS
- PRODUCT WARRANTY
- DEFINITIONS
Figure 11.2 - Viper “Scanning for Neighbors”
11.3.1 Neighbor Discovery States
s.
g in Manual-Scan, it does nothing.
Scanning For Neighbors
ning
or Table
s when the neighbor discovery module operates in
Manual-Scan mode.
Ready
The neighbor discovery module is in a “Ready” state when it is not scanning for other unit
If the Viper is operatin
If the Viper is operating in Auto-Scan, it monitors the “keep alive” packets of other units
and sends its own “keep alive” packet periodically.
The neighbor discovery module is trying to learn about other units. Other units are lear
about this unit.
Saving Neighb
In this state, the Viper is saving all neighbor entries of type "Dynamic" into
Nvram. When the save is complete, all these entries are now of type "Locked".
This state only occur
001-5008-000(Rev8) Page 106