User's Manual
Table Of Contents
- 1 VIPER OVERVIEW
- 2 SYSTEM ARCHITECTURE AND NETWORK PLANNING
- 3 DATARADIO VIPER QUICK START
- 4 VIPER WEB MANAGEMENT
- 5 UNIT STATUS
- 6 SETUP (BASIC)
- 7 SETUP (ADVANCED)
- 7.1 RF OPTIMIZATIONS
- 7.2 IP SERVICES
- 7.3 IP ADDRESSING
- 7.4 IP OPTIMIZATION
- 7.5 IP ROUTING (TABLE/ENTRIES)
- 7.6 TIME SOURCE
- 7.7 ALARM REPORTING
- 7.8 USER SETTINGS
- 8 SECURITY
- 9 STATISTICS
- 10 MAINTENANCE
- 11 NEIGHBOR MANAGEMENT
- 12 NETWORK OPTIMIZATION
- 13 UPGRADING YOUR FIRMWARE
- VIPER SPECIFICATIONS
- PRODUCT WARRANTY
- DEFINITIONS
10.5 RF TESTS
Test Tones
Allows the user to choose from Unmodulated, Random Data, and 1 KHz Sine Wave test
tone.
The test tone will transmit for 20 seconds when the "Start Test" button is clicked. The "Stop
Test" button will end the test immediately. Note: This test may cause other Vipers to stop
transmitting for the duration of the test. Viper units have a feature that checks if another
carrier (RX frequency signal) is present. If a carrier is detected, the Viper will not transmit
until the carrier is no longer present.
Figure 10.7 - Maintenance
D
RF Tests Web Page
10.6 FEATURE OPTIONS
The Feature Option web page lists the available add on features and shows which features
are currently installed in the Viper.
Table 10-1- Available Feature Options
Option # Name Description
009 SNMP Allows SNMP agent activation on the unit.
001-5008-000(Rev8) Page 103