User's Manual

#9 ViPR User Manual_Rev2.doc Page 44
 Netmask
The Netmask (default: 255.0.0.0) is set to a valid common RF IP Netmask for all units in a
ViPR network.
 MTU
Maximum Transfer Unit - Default = 1500 bytes. The Maximum transfer unit is the
maximum number of bytes the unit will send in a packet. The input range is from 576 to
1500.
 MAC
RF MAC Address, assigned by the factory. This cannot be changed.
Default Gateway
The Default Gateway (default: 0.0.0.0) allows the user to enter in the IP address of the
access point to be used as the gateway to the management network. If there is one ViPR
configured as an Access Point in the network, all the other ViPRs will set their Default
Gateway equal to the RF IP address of the Access Point.
CHANNEL TABLE
The Channel Table will display the Transmit Frequency, Receive Frequency, Transmit Power,
and Channel Type for each channel in the unit.
Figure 6.5 – Setup (Basic)
D Channel Table Web Page