User's Manual

#9 ViPR User Manual_Rev2.doc Page 25
Figure 3.1 -Demo Antenna Assembly
Note:
It is important to use attenuation between all demo units in the test network to reduce the
amount of signal strength in the test environment.
PC LAN SETUP
On a PC running MS-Windows with an existing LAN connection, connect to the Ethernet
input of the ViPR and complete the steps in section 3.3.1
Front Panel Connections
Front panel connections include: (For Dual-port ViPR connections see Section 1.3.6.)
(1) RJ-45 10 BaseT Ethernet Connection
(1) 50-ohm TNC female transmit antenna connector
(1) 50-ohm SMA female receive antenna connector (Dual-port models only)
(1) Right-angle power connector (10-30 VDC)
(2) DE-9F RS-232 ports
Figure 3.2 Front Panel (Standard model shown)
STEP 1: From the Start menu on your PC, select Settings > Control Panel > Network
Connections
STEP 2: Right click the Local Area Connection icon to open the Properties box.
Scroll through the list and highlight Internet Protocol (TCP/IP).
Click Properties to open the TCP/IP Properties box.