User's Manual

001-5008-000 rev5_2.doc Page 98
 Single Station
Single Station allows the user to enter the single RF MAC Address of the ViPR module
commands will be sent to. If this option is selected, the command will be sent to an
individual ViPR instead of being sent to all ViPRs in the Network.
 Apply
The commands will not be sent until the "Apply" button is clicked.
11.9 RECOMMENDED NEIGHBOR DISCOVERY MODES OF OPERATIONS
CalAmp recommends Auto-Scan be limited to ViPR networks of two to ten units. If Auto-
Scan mode is used, be aware the Neighbor Discovery learning process may slow responses
in SCADA networks from remote units or capture the RF channel so remotes cannot respond
to a Master.
Manual-Scan is recommended for most projects.
Disabled is recommended in projects where the customer does not want RF paths to deviate
from RF engineered (RF Site Survey completed) paths.