User's Manual

001-5008-000 rev5_2.doc Page 97
To query the ViPR for the status of all its neighbors, select the Get Status option then press
the "Apply" button under Network Management D Maintenance.
11.8 MAINTENANCE
The Network Maintenance page allows the user to make changes to a single ViPR unit or the
entire ViPR network. This allows the user to make changes to the remote units' neighbor
tables.
Figure 11.5 Network Maintenance
 Delete Station
The user enters the RF MAC Address of the station to be deleted from the Neighbor Table of
all ViPRs in the network.
 Replace Station
The user enters the old RF MAC Address (the unit to be replaced) and the new RF MAC
Address (that will replace the old ViPR). This will update the Neighbor Table of all the ViPRs
in the network.
 Change ND mode
The user can change the Neighbor Discovery mode of all ViPRs in the network to Manual-
Scan, Auto-Scan, or Disable.
 Save Configuration
This will send a save configuration command to all ViPRs in the network.
 Get Status
This will send a "Get Status" command to all ViPRs in the network. The status will be
displayed on the Network Management D Status page.