User Manual

120 40520-100a ViPR User Manual
35
4.8 Advanced IP Settings
4.8.1 Unit Status
Figure 23 - Unit Status
Item Description
Banner
Displays ViPR unit software revision information retrieved from the connected unit.
Have this information handy if contacting Dataradio support.
Station Name
Displays name of connected unit.
Configured under Setup Basic Î General Î Station Name
System ID
Displays System’s unique identification number
Configured under Setup Basic Î General Î System ID
Local Time
Displays time of configured time zone computed using UTC time and configured Time
Zone
Operating mode
Displays operating mode (Remote or Master)
Configured under Setup Basic Î General Î Operating Mode
IP Forwarding mode
Displays IP forwarding mode (Bridge or Router)
Configured under Setup Basic Î General Î IP Forwarding Mode
Sync Status
For remote unit(s) only - Displays unit sync status in relation to Master
Line not present in Figure above as unit Operating Mode is Master.
Temperature Displays unit’s internal temperature
Power Source Indicates voltage input
H/W Status
Summary report of hardware error checking at Power ON self-test. Works in conjunc-
tion with the front panel Power LED (flashing red). Displayed sentence always starts
with “HW failure…”. Unit will reset (as if power was cycled) 5 minutes after a self-test
error is detected.
Summary report of driver error detection. Works in conjunction with the front panel
Power LED (flashing green). Unit will not reset.
For both types of reports, have the displayed H/W Status message (or combination of
messages) handy if contacting Dataradio support. Also required if returning unit for
service under RMA.