User Manual
Table Of Contents
- 1.
- 1. Product Overview
- 2. Installation
- 3. Physical Description
- 4. Operation & Configuration
- 4.1 Browser-Based Setup and Status
- 4.2 LAN Setup
- 4.3 Login Screen
- 4.4 Interface
- 4.5 Setup Wizard (Bridge Mode)
- 4.6 Default IP Settings
- 4.7 IP Network Settings
- 4.8 Advanced IP Settings
- 5. Optimization & Troubleshooting
- 6. Specifications
120 40520-100a ViPR User Manual
34
4.7.4 IP Network Settings in Router Mode (with Router)
Referring to Figure 22, set one of the ViPR unit as a Master. Set the Router mode on the Master and Re-
mote. Set the Eth1 IP addresses and IP netmask of both Master and Remote.
Keep the RF IP setting as is if not using the 10.0.0.0 IP network on your Intranet.
Enable the Dynamic Registration on both Master and Remote.
Add Default Gateway to the RTU
Enable RIPv2 on Master
In the illustration, Host and RTU are part of different IP subnet.
Figure 22 - IP Network Settings in Router Mode (with Router)
ViPR Master-21
Dynamic Registration
RIPv2 / DHCP Server
Eth1 IP: 172.30.1.2
MASK: 255.255.255.0
RF IP: 10.x.y.z
MASK: 255.0.0.0
ViPR Remote
Dynamic Registration
DHCP Server
RF IP: 10.a.b.c
MASK: 255.0.0.0
Eth1 IP: 172.30.2.1
MASK: 255.255.255.0
RF Network
Router (RIPv2)
IP: 172.30.1.1
MASK: 255.255.255.0
RTU
IP: 172.30.2.2
MASK: 255.255.255.0
Default Gateway: 172.30.2.1
Host