User Manual
Table Of Contents
- 1.
- 1. Product Overview
- 2. Installation
- 3. Physical Description
- 4. Operation & Configuration
- 4.1 Browser-Based Setup and Status
- 4.2 LAN Setup
- 4.3 Login Screen
- 4.4 Interface
- 4.5 Setup Wizard (Bridge Mode)
- 4.6 Default IP Settings
- 4.7 IP Network Settings
- 4.8 Advanced IP Settings
- 5. Optimization & Troubleshooting
- 6. Specifications
120 40520-100a ViPR User Manual
12
1.2.1 Characteristics
The ViPR product has the following operational characteristics:
• An ViPR RF deck, frequency range of 406.1-470 MHz, 450-512 MHz and 136-174 MHz
• High-speed user-selectable data rates of up to 32 Kbps in full channel, 16 Kbps in half channel, and 8
Kbps in quarter channel.
• Built-in transceiver adjustable to 10 watts.
• Used as an access point or an end point with each configurable in:
♦ Bridge mode – for quick setup of units on same network
♦ Router mode - for advanced networks
• Embedded web server to access status and/or setup information.
• Remote access for over-the-air system firmware upgrades.
• Wide input power range of 10 to 30 volts DC
• AES 128-bit data encryption
• Superior data compression
• Native UDP and TCP/IP support
• Optimized IP (OIP) protocol reduction
• Diagnostics
• Supports up to 32 different frequency channel pairs
• SNMP for first-level service by non IT personnel
• RF diagnostics
• Store/Forward feature
Table 1 – On-air Data Rates, Bit and Baud Rates
Quarter Channel
Channel spacing
6.25 kHz
Half Channel
Channel spacing
12.5 kHz
Full Channel
Channel Spacing
25 kHz
Bit Rates
4-8 kb/s 8 - 16 kb/s 16 – 32 kb/s
Baud Rates
4 kHz 8 kHz 16 kHz
1.2.2 Configuration
The ViPR units are factory-configured to default settings. Configuration changes or upgrades are web
browser-based.