User Manual

3-1
Part No. 001-2100-101
SECTION 3
PROGRAMMING
Figure 3-1 JSLM
2
Field Programming Software Setup
3.1 INTRODUCTION
3.1.1 GENERAL
Section 3 describes the use of the Field Programming Software used to configure and test the JSLM
2
transceiver.
Mechanical adjustments for frequency, deviation and audio levels are described in Section 4 (Alignment and
Troubleshooting). This information is designed for use by installation personnel. Radio adjustments described in
this section should be done by technicians familiar with radio shop procedures.
3.2 JSLM
2
FIELD PROGRAMMING SOFTWARE
3.2.1 INTRODUCTION
The JSLM
2
Programmer is the Field Programming Software for tuning and programming the Dataradio JSLM
2
series data transceiver (see Figure 3-2). The Field Programming Software helps the user:
z Edit and program the programmable settings for the JSLM
2
transceiver
z Change the transmit and receive frequencies
z Monitor diagnostic data from the JSLM
2
Attenuator
Set-up
Cable
JSLM
2
6-15VDC
Spectrum Analyzer