User Manual
Table Of Contents
- Product Overview
- Installation
- Physical Description
- Operation & Configuration
- Local and Remote (OTA) Configuration
- Over-the-Air Firmware Upgrade
- Browser-Based Setup and Status
- LAN Setup
- Login Screen
- Interface
- Test & Save Parameters Buttons Behavior
- Unit Status
- Setup (General)
- Basic IP Configuration
- RF Setup
- Terminal Server Configuration
- Advanced IP Configuration
- RF Network Setup
- Broadcast / Multicast
- IP Optimization & Tuning
- Simple Network Time Protocol
- Hopper Network
- Security
- Network Statistics
- Packet Statistics
- Event Log
- RF Test
- FTP Transfer
- RSSI Table
- Manuals & Support
- Troubleshooting & Testing
- Specifications
6. Specifications
These specifications are subject to change without notice.
GENERAL
HiPR-900
Frequency
902- 928 MHz ISM band
Configurations IP Bridge, IP Gateway, IP Remote
Management HTTP embedded web server for setup and help
Supported Protocols Ethernet IEEE 802.3 (Any protocol running over IP such as ICMP, IGMP, TCP,
UDP,IPSec, SNTP etc.)
IP Fragmentation
Address Resolution Protocol (ARP)
IP directed broadcast
IP limited broadcast
IP multicast relay
DHCP Client and Server
Network Address Translation (NAT)
Dynamic Routing (RIPv2)
Channels 51
Channel Spacing
500 kHz
Operating Temperature -30° to + 60° C
Humidity 95% at 40° C non-condensing
Supply voltage
10 - 30 VDC maximum or IEEE 802.3af Power-Over-Ethernet (PoE)
Rx Current Drain at 12 VDC
<400 mA (to be determined)
Tx Current Drain at 12 VDC
<1.5 A (to be determined)
Cold start 1 8 seconds (typical)
Nominal Dimensions 5.50" W x 1.81" H x 4.25" D (13.97 x 4.6 x 10.8 cm)
Shipping Weight 2.26 lbs. (1.028 Kg)
Mounting Options Flat surface, DIN-rail option
TRANSMITTER
TX Frequencies
902- 928 MHz
Mode Frequency-hopping spread-spectrum (FHSS)
TX Power Out 0.1 to 1.0 Watts, user adjustable
Frequency Tolerance
1.0 PPM
RECEIVER
RX Frequencies
902- 928 MHz
Bit Error Rate (BER)
TBD
120 40515-100a HiPR900 User Manual
32