User Manual

4.3.3.10 IP Optimization & Tuning
Table 12 - IP Optimization & Tuning
Command Description
Optimization TCP Proxy Disabled (Default), Enabled. Actives the TCP Proxy module
Optimization Data Compression
Disabled, Enabled (Default). Applies data compression over the IP pay-
load
OIP RF ACK enable Disabled (Default), Enabled.
OIP Retries Enter number of retries. Default is 3, range 0-255
4.3.3.11 Simple Network Time Protocol
Table 13 - Simple Network Time Protocol
Command Description
SNTP – Server addr
SNTP – Enable Disabled, Enabled
SNTP – Period
SNTP – UTC Time
SNTP – TimeZone
SNTP – Daylight Savings
Off, On
Time Control – Time Sources
AirLink, SNTP
Time Control Refresh Period
Time Control Refresh TimeOut
4.3.3.12 Hopper Network
Table 14 - Hopper Network
Command Description
Dwell Displays value between 10 and 400ms
Sync Loss
Displays value between 50 and 10000ms. Indicates time a remote unit
will stop transmitting after the master is 'lost'.
Value usually at least several times the current dwell cycle time
Max Net Speed 256000, 512000(Default)
TDD Mode
Off, On( Default) –
Normally used in a point- to- point network carrying Ethernet traffic.
Maximizes RF link efficiency for bridges carrying two-way traffic
ACK Mode
Off, On
SubBand Mask
4.3.3.13 Security
Table 15 - Security
Command Description
User ID
Enter a string of any letters or numbers of at least 1 and not exceeding
15 characters
Old Password
For initial installation, enter a string of any letters or numbers of at least
8 and not exceeding 15 characters. For subsequent access, enter the
old password.
120 40515-100a HiPR900 User Manual
26