Install Guide

21
3.4.6 Antenna Connections
IMPORTANT!
THE PART OF THE ANTENNA THAT IS CONNECTED TO THE CENTRAL PIN OF THE
ANTENNA CONNECTOR SOULD BE COVERED BY ISOLATION MATERIAL WHICH IS
SUFFICIENTLY RESISTANT TO DEGRADATION BY ULTRA-VIOLET (UV) RADIATION.
Note: See 2.1.3 for antenna grounding requirements.
Connect the omni-antennas to the N-Type ANT1 and ANT2 connectors and connect the
grounding lug to the common ground.
Caution: This device has been designed to operate with the antenna described below, and
having a maximum gain of 7.15dBi. Other antennas or having an antenna with a gain greater
than 7.15dBi are strictly prohibited for use with this device. The required antenna impedance is
50Ω.
Antenna Information: MAXRAD model MFB 9155
The installation of this equipment and the antenna must be performed by a professional.