User's Manual

Vanguard 3G
CONFIGURATION
001-7000-100 Version 2 Page 30 of 66 Vanguard 3G User Manual CDMA
Version
– Default Gateway: Ethernet IP of the Vanguard 3G radio modem
– Preferred DNS: Ethernet IP of Vanguard 3G radio modem
When these settings are complete, the PC will have network access.
Static IP Setup
If your network requires each PC to have a statically set LAN IP addresses, follow the
previous procedure for all PCs on the network. If the network requires a mix of static and
dynamically assigned IP addresses, assign static IPs outside the DHCP address range for PCs
that require static IP addresses and allow the Vanguard 3G radio modem DHCP to assign the
remaining PC IP addresses.
5.4.2 Advanced (PPPoE Setup)
PPPoE Setup: PPP over Ethernet; PPPoE is used to create a password protected broadband
connection. To use this feature, configure a broadband network connection on your PC. The
procedure for setting up the broadband connection differs for different versions of Windows.
When enabled, the DHCP Server is automatically disabled and configuration is erased
Note: In most cases, PPPoE is not required and the DHCP server should be left enabled.
5.4.3 MAC Pairing
For enhanced security, the user can pair a Host PC to the Vanguard 3G unit by specifying the
Host’s Ethernet MAC address.
This ensures that only this particular host PC can send and receive traffic to and from the
WAN interface of the Vanguard 3G unit. Connections that do not have the matching source
MAC address will be blocked.
Note: Access to the Vanguard 3G unit itself is always available regardless of the Ethernet
MAC address and will not be blocked.
Status:
Vanguard 3G is unpaired: No host PC is paired with the Vanguard 3G unit. Any host PC
on the LAN can send and receive traffic to and from the WAN interface
Vanguard 3G is paired: A host PC is paired with the Vanguard 3G unit. Only the paired
host PC can pass data to and from the WAN interface.
Current Address: The current Ethernet MAC address of the paired host PC.
Note: to change the paired host PC, the user must specify the current Ethernet MAC address
of the last paired host PC.
E.G. 00:12:34:56:78:AB
New Address: Ethernet MAC address of the host PC to be paired with the Vanguard 3G
unit.
Confirm New Address: Confirm the new Ethernet MAC address of the host PC to be paired
with the Vanguard 3G unit.
Preliminary