User's Manual

Vanguard 3G
CONFIGURATION
001-7001-100 Version 1 Page 29 of 65 Vanguard 3G User Manual GSM
Version
5.4 LAN Settings
Figure 15 - LAN Settings Page
The LAN Settings page contains the basic configuration information required to customize
your LAN with the Vanguard 3G radio modem as the network connection point. User
configuration will primarily occur on this page. PPPoE settings can be found under “Advanced”
tab (see section 5.4.2).
5.4.1 IP Settings
5.4.1.1 IP Configuration
Ethernet IP address: LAN IP of the VANGUARD 3G radio modem. This address is entered
into a browser on a local PC when logging into the Vanguard 3G radio modem home page. To
decrease the chances of unwanted access, this value should be changed from its default prior
to use.
IMPORTAT NOTE:
Changing this value will cause you to lose connection to the Vanguard 3G unit.
Enter the new address in the browser to reconnect. If you forget an address or
make a mistake entering the new value, it may be difficult to reconnect to the
device.
Ethernet Subnet Mask:
The Subnet mask is used in conjunction with the Ethernet IP
address to partition the address into the network (subnet) portion and the host portion. This
value will be entered automatically by the software based on the class of IP address entered.
It is not be necessary to change the default value once the Ethernet IP is entered.
Preliminary