User's Manual

Vanguard 3G
CONFIGURATION
001-7001-100 Version 1 Page 26 of 65 Vanguard 3G User Manual GSM
Version
Subnet Mask: This subnet mask is assigned by the carrier and is not configurable by the
user.
P-t-P: WAN IP address of the network access point of the cellular carrier
GSM Connection
Service Type: Service Type indicates the type of service connection.
Service Mode: UMTS/HSDPA, UMTS/HSPA, or EDGE/GPRS
Carrier: Registered Carrier
Roaming Status: Roaming Status indicates the unit roaming status. Status is ROAMING or
NOT ROAMING.
Signal Strength: Receive Signal Strength Indication indicates the strength of the network
signal with both a numerical value and a good/medium/poor message.
Connection Status: Indicates if the device has an established connection with a carrier.
5.3 Cellular WAN Parameters
This page contains the provisioning information and the carrier activation settings. For more
information on the procedure for carrier activation, see section 4.6 “Provisioning the Vanguard 3G
Radio Modem”.
5.3.1 Status
WAN Status information is available (Figure 14).
Service Type: Service Type indicates the type of service connection.
Service Mode: UMTS/HSDPA, UMTS/HSUPA, or EDGE/GPRS
IMEI: International Mobile Equipment Identity
MIN/MSI: Mobile Identification Number; in most cases, this is the same as MDN
Country: Country where the unit is located
Carrier: Registered Carrier
Band: North America (850/1900 MHz), Europe (900/1800 MHZ), or Australia (850/2100
MHz)
Cell ID: Status only. Assigned by carrier when connecting to the network
Roaming Status: Roaming Status indicates the unit roaming status. Status is ROAMING or
NOT ROAMING.
Signal Strength: Receive Signal Strength Indication indicates the strength of the network
signal with both a numerical value and a good/medium/poor message.
Connection Status: Indicates if the device has an established connection with a carrier.
Preliminary