Hot Tub User Manual

2011 Genesis Portable Spa

LTR20111058, Rev. B

Cleaning and Maintenance

www.c a l s p a s.c o m

Winterizing (Cold Climate Draining)

In many areas of the country, the temperature drops

below 32˚F (0°C). We recommend that you always

have your spa full of water and running at normal spa

temperatures (80˚F to 100˚F, 26.7°C to 37.8°C). This

will help reduce the risk of freezing in your spa and

your spa’s equipment.

Warning:Ifyoundtheneedtodrainyourspa,

please be aware of the potential of freezing in

your spas equipment and plumbing. Even if the

directions below are followed perfectly, there

is no guarantee that your spa will not suffer

freeze damage.

Freeze damage is not covered by your war-

ranty.

Open all lter covers.1.

Remove the lter baskets and lters.2.

Drain your spa completely as described in the in-3.

structions above.

Remove drain plugs from the front of the 4.

pumps.

Disconnect the unions from both sides of the 5.

pump.

Use a wet/dry vacuum to blow any remaining 6.

water out of the jets and equipment area.

Cover your spa with a good spa cover and an all-

weather tarp to ensure that neither rain nor snow

enters the spa.

Installing Cover Latches

You will need a drill with a 3/32” drill bit and a Phillips screwdriver.

Your cover will have four clips attached to the ends of the four latches, two on each end of the spa cover.

There will also be a small bag with 12 screws.

Place the cover on the spa with the latches placed 1.

where you want to mount them on the spa.

Using the latch clips as a guide, drill three 2.

holes for the mounting screws.

Insert three screws in the latch clip and fasten it to the spa shell. 3.

Make sure they are snug, but do not overtighten them. Do the

same for the remaining latches. Drill and attach latch clips to the

shell one at a time.

When you have nished inserting 4.

all of the screws, use the latch

key to unlock the cover latches.