Instruction Manual

6605 Flotilla St. Commerce, CA 90040 USA
Tel: 800-876-9258; 323-888-6601 ; Fax: 800-222-3316; 323-8886699
Web: www.cal-royal.com ;Email: sales@cal-royal.com
REGULAR ARM INSTALLATION TOP JAMB INSTALLATION PARALLEL ARM INSTALLATION
Installation Instructions
CLOSER ADJUSTMENT
Surface Mounted
Interior Door Closer
Model: 700 Series
Sizes: 2, 3, 4 and 5
Optional Back check
Closer is installed on PULL/HINGE
side of door
Closer is installed on frame on
PUSH/STOP side of door
Closer is installed on PUSH/STOP
side of door
Illustration:
Non Hold Open Arm
Left Hand Door - LH or
Right Hand Reverse - RHR
Illustration:
Non Hold Open Arm
Right Hand Door - RH or
Left Hand Reverse - LHR
Illustration:
Non Hold Open Arm
Right Hand Door - RH or
Left Hand Reverse - LHR
SEE PAGE 2 SEE PAGE 3 SEE PAGE 4
CLOSING CYCLE
NOTE: Closing arcs (”CLOSE” and “LATCH”) are controlled by two (2) separate speed valve adjuster.
Adjust the CLOSING speed first, then adjust the LATCHING speed.
1. “CLOSING” speed adjustment is accomplished by full rotations of the speed valve adjuster.
- Turn the speed valve screw CLOCKWISE for a slower close arc closing speed.
- Turn the speed valve screw COUNTER-CLOCKWISE for a faster close arc closing speed.
2. “LATCH” speed adjustment is accomplished by full rotations of the speed adjuster valve.
- Turn the speed valve screw CLOCKWISE for a slower latch arc closing speed.
- Turn the speed valve screw COUNTER-CLOCKWISE for a faster latch arc closing speed.
CAUTION!! Do not turn speed adjuster valve more than two (2) full turns counter-clockwise from its factory
default position, as the two speed valve adjusters could become dislodge from the door closer body,
resulting in the loss of internal fluid and failure of the device.
PUSH SIDE PUSH SIDE
PULL SIDE PULL SIDE
LEFT HAND DOOR RIGHT HAND DOOR
CLOSING SPEED
SPEED VALVE SPEED VALVE
CLOSINGLATCHING
LATCHING SPEED
12
ILLUSTRATION TO DETERMINE HAND OF DOOR
Page 1
DWG. # DCG1029 - 1/4 - AUG2022

Summary of content (4 pages)