Specifications

Page 66 of 76 SmartSource 2-Stage Water Source Heat Pumps Catalog 1114-1
Engineering Guide Specications
Unit mounted LED annunciators aid in diagnosing unit operation by indicating the water source heat pump operating mode
and alarm conditions. If there are no current alarm conditions, a green LED on the annunciator board will indicate occupied
unit operating mode. If an alarm condition exists, the MicroTech III SmartSource unit controller will send the fault condition
to the LED annunciator, which will assist in troubleshooting the unit. Heat pumps with the MicroTech III SmartSource unit
controller with a LonWorks Communication Module is designed to be linked with a centralized Building Automation System
(BAS) through a LonMark communications network for centralized scheduling and management of multiple heat pumps.
Wall-mounted room sensors are available to control the heating and cooling operation of each MicroTech III Water Source
Heat Pump.
Warranty
• An optional 2, 4, or 10-year extended compressor warranty covers the compressor from the date at which the unit ships
from the factory.
• An optional 2, 4, or 10-year extended refrigeration circuit warranty covers the entire refrigeration circuit and related
components for 5 years.
Field Installed Accessories and Options
WallThermostats:
• Programmable Touch Screen Thermostat
1. Optional Remote Room Sensor
2. Optional Outdoor Temperature Sensor
• Non-Programmable Thermostat
1. Optional Remote Room Sensor
• Programmable Thermostat
1. Optional Remote Room Sensor
WallMountedRoomTemperatureSensors
• Digitally Adjustable Wall Sensor with Temperature and Humidity Display
• Adjustable Cool/Warm with Occupancy Switch, Override/Reset Button, Status LED, Fan and System Switch
• Adjustable 55°F to 95°F and 12°C to 33°C, Override/Reset Button, Status LED, Fan and System Switch
• Adjustable-5°F to +5°F and -21°C to -15°C, Override/Reset Button, Status LED, Fan and System Switch
• Basic Sensor, Override/Reset Button, Status LED
Humidistat
To be used in conjunction with one of the dehumidication options. Humidistat to be wall mounted and capable of providing
solid state input to unit controls to enable/disable dehumidication features.
Hose Kits
Two re-rated exible hoses with ASTM ratings of Flame Spread 25, Fuel Contribution 25 and Smoke Density 50 for con-
nection to unit and eld piping. Hose shall be covered with stainless steel braiding to prevent damage.
Condensate Hose Kits
• Optional plastic hose including ttings
• Optional re-rated, braided steel hose including ttings