Use and Care Guide
Convection Grills
LTR50001038, Rev. E
Cleaning and Maintenance
www. c a l a m e bb q . c om
29
Dry all of the components thoroughly to prevent
water damage.
Replace the burners6.
Before you replace the burners, inspect the gas
valve orices for cleanliness and condition and
the location of the igniters.
Set the ame tamers in place before you replace
the burners.
Carefully insert the burner into the opening for
the valve orice and gently slide it in. Then set
the other end of the burner down so the anchor
post rests in the hole.
When you replace the
burners, you don’t need
to replace the locking
pins.
Replace the 7.
components
Put all of the components
back as they were, as
shown in step 1.
Inspect each burner for damage, such as cracks and holes. If any damage is found, don’t use the grill until
you replace the burner.
Clean the grill interior
4.
While the burners are out of the grill, you can use this opportunity to clean the interior of your grill
thoroughly. You should still have the drip pan in place to catch water and grime as you clean the grill
interior.
When the grill interior is clean, remove the drip pan. Dump out any water and grime residue and spray it
off with a garden hose.
Dry both the grill interior and the drip pan thoroughly to prevent water damage.
Clean the components5.
You can clean the racks by rst soaking them in warm water and dish detergent and scrubbing them with
a wire brush.
Clean the avor bars and the ame tamers with dish detergent. You can use any kind of scrubber you wish:
a non-abrasive pad, steel wool, or a wire brush, depending on your needs.