Use and Care Guide

Convection Grills
LTR50001038, Rev. E
Appendix
www. c a l a m e bb q . c om
35
Screw on the correct orice for your grill until it d.
is nger tight.
Tighten the orice with the wrench.e.
If you have dual infrared burners, repeat the f.
previous steps for the second burner.
Replace the back cover.g.
Unscrew the back cover from the grill and lift it a.
up and under the grill hood.
Using a wrench, remove the orice for the b.
infrared burner.
Apply pipe compound to the tting threads
c.
where you will place the new orice.
You will need:
Either a 13mm or 10mm open end wrench
•
One #52 orice (for single infrared burner) •
OR
Two #54 orices (for dual infrared burners)•
Pipe compound suitable for natural gas•
You will need:
7mm wrench, socket, or nut driver•
One or two 1.75mm orices (depending on •
your side burner)
Pipe compound suitable for natural gas•
Remove the grate, burner cap and burner a.
diffuser from the side burner.
Using a 7mm wrench, remove the orice for b.
the burner.
Apply a small amount of pipe compound to c.
the orice threads.
Screw in the orice until it is nger tight.d.
Tighten the orice with the 7mm wrench.e.
If you have dual side burners, repeat the f.
previous steps for the second burner.
Mark the rating plate4.
After conversion has been completed, mark the rating
plate as NG with an indelible marker.
Gas Conversion (continued)
Replacetheinfraredburnerorices2.
Replacethesideburnerorices3.