User`s guide

- 47 -
12.6. SETUP
You can modify the display mode (measurement or detection) and load the time
and/or the date of the MX2000.
The Code button enables you to alter the access code.
The Patrol button can be used to alter the patrol list.
Note : All modification of setup « purges » the histories.
§ CHANGING THE ACCESS CODE
After clicking the Code button in the Setup section, proceed as follows to alter
your access code :
- enter your current code (4 digits) and validate by pressing the Enter key,
- enter your new code and validate either by pressing the Enter key or by
clicking on the Ok button.
If you forget your code, please contact OLDHAM.
§ ALTERING THE PATROL LIST
After clicking the Patrol button in the Setup section, you can alter the order and the
content of the patrol list.
Any alteration of the patrol list will result in a purge of all histories.
To add a patrol, enter his name (8 characters maximum) then either click on the Add
button or press on the Enter key (30 patrols maximum).
To remove a patrol from the list, select the name, and either click on the Delete
button, or double-click it.
To reset the list, either press on the Del key, or click on the Delete all button.
To change the order of the list, click on the desired position and move it by keeping
the mouse button pressed (drag it). When you reach the chosen location, release the
mouse button and the moved position will be inserted there.
Validate the operation by clicking on the Ok button.