Use and Care Manual

Operation

Fire Pit Owner’s Manual

LTR50001010, Rev. M

and replace any part of the control system and any gas control

which has been under water.

• Make sure the ignitor battery has been installed properly. Ignitor

will not operate properly without a battery installed.

Lighting Instructions for Automatic

Starter

1. Locate the manual gas control valve and igniter button on the re-

place.

2. Make sure fuel supply is properly connected and turned on at the

source.

3. Depress igniter button until you hear it sparking. You will hear a

small popping noise. Keep igniter button pushed in while slowly

turning the fuel ow valve to the full ow position at the replace.

The replace should light within 5 seconds. If you do not hear the

igniter sparking you may need to replace the battery. The starter

uses one standard AAA battery, located directly behind the rubber

push button knob. (Unscrew knob to access battery.) Note some

models ship with the batteries removed or may not be included

with your model.

4. If a ame does not start within 10 seconds, shut off all gas supply

and wait ve minutes to allow all gas fumes to clear. Re-try or go

to trouble-shooting and start again from step 1.