Use and Care Manual
6
Installation / Assembly
Fire Pit Owner’s Manual
LTR50001010, Rev. M
Placement and Location
Cal Flame replaces and repits are designed for 
outdoor use only.
•  Never locate this appliance in a building, garage, or any other en-
closed room or under a sealed overhead structure, or in any type 
of enclosed area such as a garage, shed, or breezeway. Keep clear 
of trees and shrubs.
•  Do not place replace or re pit under or near windows or vents 
that can be opened into your home.
•  Maintain sufcient distance as to not overheat any overhead com-
bustible material such as a patio cover.
•  The area surrounding your replace or repit should be kept clean 
and free from ammable liquids and other combustible materials 
such as mops, rags or brooms, as well as solvents, cleaning uids, 
and gasoline.
•  Do  not  block  the  vents  located  near  the  base  of  your  repit  or 
replace as  gas may  build up  in case  of leak  and cause  serious 
damage.
•  Do not install or operate your replace in such a manner that the 
cross ventilation openings are blocked. Fresh air must be able to 
pass though installed vents to safeguard against residual gas ac-
cumulation.  Failure to allow proper ventilation may cause re or 
explosion.
•  Do not locate appliance where it can get excessively wet. Do not 
use this appliance if any part has been underwater. Immediately 
call a qualied service technician to inspect the unit and to replace 
any part of the control system and any gas control which has been 
underwater.
•  Place  your  repit  or  replace  on  a  at  and  stable  surface  in  an 
outdoor location such as a patio deck. 
•  Locate your repit or replace adjacent to the gas supply line (liq-
uid propane or NG), preferably with the shortest gas line run pos-
sible. 
•  Maintain the following clearances to combustible materials on all 
Cal Flame replaces and re pits.
  Sides and back  48 inches (122 cm) (measured from side)
  Top     120 inches (305 cm) (measured from hearth)










