Specifications

Traditional Chemical Start Up
Page 14 Cal Spas Clear Water Plan
LTR20061023, Rev. A
Cal Inline Sanitation System Clear Water Plan
This plan and its chemical dosages are
intended for spas equipped with the
optional Cal Inline Sanitation System.
The chemical references are designed
for Cal Spas chemicals only. Note:
Following these instructions is very
important to ensure proper operation of
your Cal Inline Sanitation System.
Start Up -- First Day
1. Clean surface of spa with Cal
Spas “Multi-Purpose Cleaner”.
2. Apply a protective coat of Cal
Spas “Fast Sheen” to the acrylic
surface.
3. Fill spa to proper water level with
normal tap water (Do not use soft
water)
4. Use Bromine Test Strip and
balance the spa water:
• First, adjust total alkalinity
(acceptable range is 80-
120ppm),
• Then adjust pH if necessary. (between 7.2 to 7.8)
a. Pour in 16 oz of Cal Spas “Metal Protector” to center of spa.
b. Sprinkle 1 oz of Cal Spas Chlorinating Granules over surface of water.
c. Power up spa and allow it to heat to desired temperature.
Start Up--Next Day
Now that the spa has reached its normal operating temperature, it is time to add the pre-filled mineral cartridge
and bromine cartridge.
1. Turn the power off to the spa.
2. Take a new Cal Spas “Mineral Cartridge” and open to #6. (Hold the top of the cartridge and turn the
bottom counter clockwise)
3. Take a new Cal Spas “Bromine Cartridge” and open to #3 (if the spa is less than 400 gallons, open to #2)
Note: These settings are start up settings only. They may need to be adjusted up or down depending on
your spa usage.
4. Unscrew the Cal Inline Sanitation System Cap located on the top lip of the spa.
5. Grasp the handle of the cartridge holder and turn counter-clockwise then pull up.
6. Remove the cartridge holder and discard spent cartridges (if any)