User manual

56
 Remote IP Address
Sets the IP address of the device using the PAD functionality
 Remote Port
Sets the port number used by the remote device to accept requests from the Vanguard
 Local Port
Sets the port number used by the Vanguard to accept requests from the remote device
 PAD Mode
Select buttons to set the PAD mode of the Vanguard as a Server or Client
 Pad Protocol
Sets the data protocol of the PAD to tcp or udp data
 TCP Client Keep Alive
When in client mode and enabled, TCP Keep Alive packets will be sent from the client to the server periodically in
order to detect a broken connection. The modem will automatically try to re-establish the connection if necessary.
Changing this setting will affect the use of TCP Keep Alive on the next client session. It will not affect an existing
session. When this option is enabled, the timing and number of Keep Alive attempts is controlled by parameters
defined on the External Serial page. It is not possible to have different timing settings for each serial port
 PAD Log
If enabled, a log of the data passed through the modem is saved at /tmp/intpadlog. The log will stop saving data
when full and data is lost at modem reset.
3.9 DIAGNOSTICS
From the main navigation pane, select Diagnostics for access to the SNMP and Logging screens.
3.9.1 SNMP
The Simple Network Management Protocol (SNMP) is used in network management systems to monitor network-attached
devices for conditions that warrant administrative attention. SNMP version v2c and v3 are supported with the exception of
INFORM.