User manual

32
Dial Settings
 Auto Connect
When set to Enable, will allow the modem to automatically dial the connection when the modem is powered.
When set to Disable, the modem will not automatically dial the connection to the cellular provider and will not
attempt to automatically re-connect when the connection has dropped.
 Dial Number
The phone number used to initiate a data connection to the cellular provider via PPP. The default dial number is
#777.
 User
Sets the username required by the cellular provider. Leave blank if not required. Warning: If used in combination
with this modem's VPN Server, this username and password will also be valid on this modem's VPN Server.
 Password
Sets the password required by the cellular provider. Leave blank if not required.Warning: If used in combination
with this modem's VPN Server, this username and password will also be valid on this modem's VPN Server.
 Authentication
Select the authentication protocol used. If Auto is selected, the Vanguard will automatically select a protocol. If
Only Protocols Selected Below is chosen, the router will only accept requests for the specified protocols.
 Authentication Protocols
If Only Protocols Selected Below is chosen, then these fields are used to specify each Authentication protocol that
router will accept. At least 1 must be selected. If Auto is selected, these choices will be disabled (greyed out).
 Dial Status
Click “View” to see a log from the last connection attempt.
The SAVE button must be pressed for changes to take effect.
3.4.2 SYSTEM MONITOR
Select Cell Connection from the left navigation pane. The System Monitor tab allows user access to the configuration of
additional self-monitoring for the modem to determine when service provider connections may have been terminated.