Reference Guide

894 Mixing
Signal flow
Track selection controls are labeled with track numbers, while bus selection controls are labeled with
letters (A-Z, AA-AZ, etc.).
Figure 278. Bus selection control
A. Bus letter
Select tracks/buses that are assigned to a specific bus
You can quickly select all tracks and buses that are routed to a specific bus (via outputs or sends).
To do so, hold down the ALT key and click the bus’ Select control in the Track view or Console view.
To display the audio waveform of a bus
• Enable the bus’ Waveform Preview button . This displays the waveform of the audio that is
flowing through the bus.
To do this Do this
Select a bus Click the bus letter in the Track view or Console view. The bus is
selected, and all other buses—except the current bus—are deselected.
When a bus is selected, both the bus letter and all the data in the bus
appear highlighted.
Select several adjacent buses Click the bus letter for the first bus in the group, drag the mouse to the
last bus letter in the group, and release the mouse button.
Select/deselect all buses Double-click a bus letter.
Add or remove a single bus from the
selection
Hold the SHIFT key and click the bus letter to add it to the selection;
hold the CTRL key and click the bus letter to toggle its selection status.
Select all tracks and/or buses that
are assigned to a bus.
Hold down the ALT key and click the bus letter.
Table 164.
A