Reference Guide

874 Software instruments

ReWire

Mixing down ReWire instruments

To either mix down or bounce ReWire instruments to new audio tracks, use the same procedures as

for synths.

See also:

“Inserting a ReWire instrument” on page 871

“To use separate synth tracks for each ReWire device” on page 873

“Mixing down ReWire instruments” on page 874

“ReWire troubleshooting guide” on page 874

“Inserting a ReWire instrument” on page 871

ReWire troubleshooting guide

The following lists some common issues when you use ReWire with SONAR:

• SONAR Won’t Close Properly. Always close your ReWire applications before closing SONAR

or a SONAR project.

• Rebirth Won’t Play After I Open Its Property Page. Make sure that the Loop switch in Rebirth

is enabled.

• My ReWire Project Plays at a Different Tempo when Opened from SONAR. When you open

a ReWire project from SONAR, the ReWire project assumes SONAR’s default tempo, which is

100. Change SONAR’s tempo to match your ReWire project.

• My MIDI Controller Works in SONAR or my ReWire Application, but not Both. Choose

different MIDI In ports for both SONAR and your ReWire application. Do this in SONAR by using

the Edit > Preferences > MIDI - Devices command, and highlighting the MIDI In port you want to

use in SONAR. If you only have one MIDI In port on your MIDI interface or sound card, enable

that input in either SONAR or your ReWire application, and disable that input in the other

application.

• I Get a MIDI Input Error Message When I Open a ReWire Application. If you only have one

MIDI Input port on your MIDI interface, you probably have that one reserved for SONAR, leaving

none for your ReWire application. If you would rather use your MIDI controller in the ReWire

application instead of SONAR, you can deselect your MIDI input port in Edit > Preferences >