Reference Guide

643
Editing transient markers
AudioSnap (Producer and Studio only)
Editing transient markers
Transient markers show where the transients of a clip are (areas where the level increases
suddenly), and are used to edit the timing of audio clips.
AudioSnap finds transients automatically, but the transient markers don’t always appear exactly
where you might want them for the kind of editing you want to do.
Most AudioSnap commands edit transient markers automatically as a result of an editing operation,
but sometimes you achieve the best results by editing the markers manually.
You can edit the markers by moving them to new locations, adding markers, filtering out markers,
deleting markers, and promoting markers (protecting them from being filtered).
Figure 224. Transient markers
See:
“To select a transient marker” on page 644
“To select multiple adjacent transient markers” on page 644
“To select multiple discontiguous transient markers” on page 644
“To select the same transient in multiple clips” on page 644
“To extend a multi-track marker selection” on page 645
“To select all similar transient markers in a clip” on page 645
“To move a transient marker (without stretching audio)” on page 646
“To drag a transient marker and stretch audio” on page 646
“To stretch multiple transient markers in a clip” on page 646
“To stretch multiple transient markers in a clip proportionally” on page 646
“To reset transient markers” on page 647
“To disable a transient marker” on page 647
“To delete a transient marker” on page 647
“To insert a new transient marker” on page 647
“To copy transient markers from one track to another track” on page 648
“To enable/disable transient markers” on page 648
“To navigate to the next/previous transient (TAB to transients)” on page 649
“Transient marker appearance” on page 649
“Transient marker context menu” on page 650