Reference Guide

601
Properties Inspector overview
Inspectors
To show/hide the Track Properties Inspector
Click the Track button at the top of the Inspector pane, or press CTRL+SHIFT+I.
Figure 208. Click the Track button to show/hide the Track Properties Inspector.
The Track Properties Inspector contains the following sections:
Properties section
• Track Name. Assign a name to the selected track.
AudioSnap section (audio tracks only)
• Online Render. Specify the algorithm to use during real-time playback. For more information
about render modes, see “Algorithms and rendering” on page 692. The options are as follows:
• From Global. This uses the algorithm listed in the Online field in Edit > Preferences >
Project - AudioSnap.
• Groove clip. Works faster than Percussion render mode, using less processing power.
• Percussion. Works better than the Groove Clip render mode on percussive material,
especially if the stretching is by more than a few beats per minute.
• Offline Render. This drop-down menu lets you choose the algorithm that is used when you
export or freeze stretched audio. The choices in the drop-down menu are as follows:
• From Global. This uses the algorithm listed in the Offline Rendering field in Edit >
Preferences > Project - AudioSnap.
• Radius Mix. Better for clips containing polyphonic, stereo data.
• Radius Mix Advanced. Similar to Radius Mix, but exposes a Smoothing slider that adjust
how much detail to preserve.
• Radius Solo. Better for clips containing monophonic, solo instruments.
• Radius Solo (Bass). Better for clips containing solo bass instruments.
• Radius Solo (Vocal). Better for clips containing solo vocals.
• Same as Online. Uses the same choice as the Online field.
Note: The Online render mode is for preview purposes only during playback. The final audio
quality will be greatly improved after the Offline render mode is applied during mixdown/export.