Reference Guide

576 Inspectors
Track Inspector overview
To edit multiple tracks/clips simultaneously
You can use the Track Properties and Clip Properties inspectors to modify multiple selected tracks
or clips simultaneously. The following rules apply when modifying multiple tracks/clips:
• If the selected tracks or clips share the same value for a parameter, that parameter will display
normally.
• If the selected tracks or clips have different values for a parameter, that parameter will display as
(Multi).
• If the selected Tracks or Clips are of a different type and it would not be appropriate or possible to
modify a parameter, that parameter will be unavailable.
See:
“Track Inspector overview” on page 576
“Properties Inspector overview” on page 592:
“Properties Inspector - Clip Properties” on page 594
“Properties Inspector - Track Properties” on page 600
“Properties Inspector - Bus Properties” on page 603
Track Inspector overview
The Track Inspector provides mixing controls for the currently selected audio track, MIDI track,
Instrument track, bus or main. The Track Inspector is essentially identical to a channel strip in the
Console view. Any changes you make in the Track Inspector are reflected in the corresponding
Console view channel strip, and vice versa. The Track Inspector modules can be shown/hidden
independently from the corresponding Console view modules.
The Track Inspector is divided in two. The left strip shows mix controls for the current track/bus/
main. The right strip varies depending on the current track type, as shown in the following table.
Current track type Left strip Right strip
Audio Selected audio track Output of selected track or send
MIDI Selected MIDI track Arpeggiator, Input Quantize, Snap to Scale settings,
MIDI chorus, MIDI reverb, Bank Select Method,
Key+ and Time+ for selected MIDI track
Instrument Selected Instrument track Audio tab: Output of selected track or send
MIDI tab: Arpeggiator, Input Quantize and Snap to
Scale settings for selected Instrument track
Table 114. Track inspector controls