Reference Guide

550 Control Bar overview

See also:

“Tools module” on page 541

“Snap module” on page 544

“Loop module” on page 550

“Mix module” on page 552

“ACT module” on page 554

“Screenset module” on page 556

“Performance module” on page 558

“Punch module” on page 560

“Select module” on page 561

“Markers module” on page 562

“Event Inspector module” on page 564

“Sync Module” on page 566

“Gobbler module” on page 568

Loop module

The Loop module lets you control loop settings.

To show/hide the Loop module

Right-click the Control Bar and select Loop Module.

Figure 181. The Loop module.

A. Loop On/Off B. Set Loop Time to Select C. Loop Start Time D. Loop End Time

The Loop module contains the following controls:

• Loop on/off . Enable/disable playback looping.

• Set Loop Points to Selection . Set the Loop Start time to the start (From) time of the

selection, and the Loop End time to the end (Thru) time of the selection.

• Loop Start Time. The current Loop Start time. Click to modify.