Reference Guide

459
Smart tool
Tools
Using the Smart tool in Take lanes
Figure 128. Smart tool hotspots in Take lanes (two split clips shown).
Hotspot Default action +ALT +CTRL +ALT+SHIFT Right-click
A Adjust fade in
B Adjust fade out
C Crop clip start Stretch clip Crop clip start
and also move
clip data
D Crop clip end Stretch clip Crop clip end
and also move
clip data
E Drag the top half to
select by time.
Drag the bottom half to
isolate.
Drag to lasso
select
F Click to isolate clip.
Drag to split across lanes
and Isolate clip.
Split clip Click to toggle
clip mute
status
Move data within
clip
Drag to lasso
select
G Click the clip header to
select the clip, or drag
the header to move the
clip.
Split clip Click to toggle
clip selection
status
Move data within
clip
Drag to lasso
select
H (split
point)
Drag left/right to move
split point on all Take
lanes; if crossfade exists,
move the crossfade
Drag up/down to extend
overlaps with crossfades
Drag to lasso
select
Table 70. Using the Smart tool in Take lanes
A B
C D
F
G
E
H
Clip 1 Clip 2