Reference Guide

277
Preparing to record
Recording
applications. In this timebase, each quarter note is represented by 960 ticks, each eighth note by
480 ticks, each eighth-note triplet by 320 ticks, and so on.
In some projects you may need a different timebase. For example, if you wanted to use eighth-note
septuplets (7 eighth notes per quarter note) and represent them accurately, you would need to have
a timebase that is divisible by 7, such as 168PPQ. SONAR uses the timebase you choose for a
project to determine the range of tick values in the Now time.
To set the timebase for a project
1. Go to Edit > Preferences > Project - Clock.
2. Choose the timebase you want from the Ticks per Quarter Note list.
3. Click OK.
The timebase will be saved with the project file.
Preparing to record
To prepare for recording, you need to do the following:
• Set the recording mode.
• Choose your input(s).
• Arm one or more tracks for recording.
• Check your recording levels (audio only).
• Tune your instrument if necessary (audio only).
• Set the Now time to the point where recording should start.
• Start recording.
After you record, you can use the Edit > Undo command to erase the most recently recorded
material. You can use the Edit > Redo command to restore the recording and toggle between Undo
and Redo as many times as you like. If you are using MIDI Sync or time code sync for the clock
source, SONAR waits to receive external timing data before it begins recording. For more
information, see “Synchronizing your gear” on page 1265.
See:
“Recording modes” on page 278
“Choosing an input” on page 279
“Arming tracks for recording” on page 281
“Auto arming” on page 282