Reference Guide

2010 View reference
Loop Construction view
• Loop Properties. Opens the Loop Properties dialog box.
Slice menu
The Slice menu contains the following commands:
• Reset Markers. Restores all automatically generated markers to the original position and
enables all those that were disabled. Manually created markers remain as is.
• Show/Hide Gain Envelope. Toggles on or off the display of a gain envelope.
• Show/Hide Pan Envelope. Toggles on or off the display of a pan envelope.
• Show/Hide Pitch Envelope. Toggles on or off the display of a pitch envelope.
• Next Slice. Moves the slice selection to the next slice in the loop. You can also press the PAGE
DOWN key.
• Previous Slice. Moves the slice selection to the previous slice in the loop. You can also press
the PAGE UP key.
Options menu
The Options menu contains the following commands:
• Auto Slice Preview On/Off. Turns on slice auto preview.
• Auto Slice Preview Loop On/Off. This control is only available if the Enable Slice Auto
Preview option is on. This option loops the slice auto preview.
• Preview Bus. Select the output through which you want to listen to the clip.
Controls
• Preview . Plays the current loop repeatedly. Click again to stop preview.
• Loop. Click the Loop button to loop clips in the Track view by dragging the right side of a clip
with your mouse. When Loop is not on, you are able to slip-edit the clip.
• Resolution. The slice Resolution control sets the resolution for the creation of markers, or the
“slicing” of the looped clip. This control uses the following note durations:
• No Slice
• Whole Note
• 1/2 Note
• 1/4 Note
• 1/8 Note
• 1/16 Note
• 1/32 Note
Note: The settings in the Loop Properties dialog box are also available in the Groove Clip
section in the Clip Inspector.