Reference Guide

1884

Select By Time dialog

The Edit > Select > By Time command opens the Select by Time dialog box.

Choose the starting and ending times for the time selection you want to make by entering numbers

into the following fields:

• From. Enter the number of the measure, beat, and tick of the location where you want the

selection to start.

• Thru. Enter the number of the measure, beat, and tick of the location where you want the

selection to end.

The From and Thru times you select appear in the Select toolbar in the From and Thru fields. If you

select a whole measure, the Thru time is the start of the next measure, which actually makes it a “to”

time and not a “through” time.

For more information, see:

“To select partial clips using time ranges and tracks” on page 368

Set Default Velocities for Steps dialog

Open the Set Default Velocities for Steps dialog by right-clicking to the right of any row in the Step

Sequencer and selecting Set Default Velocities for Steps from the pop-up menu.

From the Set Default Velocities for Steps dialog box you select the default velocity value that is

assigned to new notes that are enabled in the Step Sequencer. The setting is global, which means it

applies to all step sequencer clips and projects.

Select Fretboard Track dialog

Open the Pick Fretboard Track dialog box by right-clicking in the Fretboard pane and selecting

Select Track from the Fretboard pop-up menu.

From the Pick Fretboard Track dialog box you select the track you want to see displayed in the

fretboard pane if multiple tracks are displayed in the Staff pane.

To select a track, click the track in the Pick Fretboard Track dialog box and click OK.