Reference Guide

1660
Set Default Value
Set Default Value
The Set Default Value command sets the default value for the FX Chain knob or button. When you
double-click the knob or button, it returns to its default value.
See:
“To set the default parameter value” on page 940
All Parameters - Set Start
The All Parameters - Set Start command sets the Start value for all plug-in parameters assigned to
the FX Chain knob or button. The values are determined by the current position of each plug-in’s
property page settings.
See:
“To set parameter value range automatically” on page 940
All Parameters - Set End
The All Parameters - Set End command sets the End value for all plug-in parameters assigned to
the FX Chain knob or button. The values are determined by the current position of each plug-in’s
property page settings.
See:
“To set parameter value range automatically” on page 940
Learn Knobs
The Learn Knobs command puts the FX Chain into a learning mode and will 'listen' to controls
touched on the plug-ins in the FX Chain. When you select Learn Knobs again, the touched controls
are assigned and displayed in the FX Chain property page. Learn mode is automatically ended if the
limit of 6 knobs is reached.
See:
“To add/remove an assignable knob or button” on page 939
“To map an assignable knob or button to a plug-in parameter” on page 941